CFS210 Cyber Defense Fundamentals · CySA+ CS0-004 Bootcamp · PBQ Simulation 3 of 5

Analyzing Nmap Output and Configuring Firewall Rules

A practice performance-based question set at the fictional Tamberlin Health Network. Suggested time: 12 to 15 minutes.

How this simulation works

  1. Read the scenario, then open each exhibit tab. The exhibits hold everything you need to answer the tasks.
  2. Complete every task, then select Submit answers. Scoring gives partial credit where a task has more than one part, the same way CompTIA can award partial credit on PBQs.
  3. After you submit, each task shows the correct answer and an explanation. Select Reset simulation to clear your work and try again.
  4. On the real CySA+ exam, PBQs are simulations. You can flag a simulation, skip it, and return to it after you finish the multiple-choice questions, and each simulation has a reset button.

CS0-004 objectives practiced:

  • 1.1 System and network architecture concepts
  • 1.2 Analyze indicators of potential malicious activity
  • 2.2 Analyze output from vulnerability assessment tools

The organization, people, and events in this simulation are fictional. Public IP addresses come from the RFC 5737 documentation ranges and domain names use the reserved .example top-level domain, so none of them route anywhere. This is a practice activity and is not graded.

Pacing timer

Elapsed time:00:00

Scenario

Tamberlin Health Network hosts two public servers in its DMZ: a web server and a mail relay. An authorized external scanning service ran Nmap against both servers from the internet. Compare the results to the approved service baseline, then configure the DMZ inbound firewall rule set.

Exhibits

Approved DMZ service baseline

  • web01 (198.51.100.5): HTTPS on 443/tcp for everyone. HTTP on 80/tcp only so the server can redirect visitors to HTTPS.
  • mail01 (198.51.100.6): SMTP on 25/tcp for inbound mail delivery.
  • SSH on 22/tcp to DMZ servers is approved only from the internal management network 10.20.9.0/24. It must never be reachable from the internet.
  • Remote Desktop (3389/tcp) and Telnet (23/tcp) are prohibited on all DMZ servers.

Tasks

Task 1 (3 points)

Select every open port in the Nmap output that violates the approved service baseline. Select all that apply.

Task 2 (1 point)

What does the state 'filtered' mean for 8080/tcp on mail01?

Task 3 (8 points)

Set each rule in the DMZ inbound rule set to Allow or Deny so the rule set meets every firewall requirement.

Task 4 (1 point)

An engineer proposes moving R5 above R4. What would happen to SSH sessions from the management network?